Design know how in the following areas :
Design of components and systems in NX 11 Powertrain areas
Expertise in tools TcAE
Knowledge of engine system
Knowledge of ASME (GD&T)
Work out design studies and design alternatives
Senior : 5 years experience, minimum, as per requirements
English language : autonomous in written communication.
3D LAYOUT STUDIES
3D detailed study of subsystems and component.
The components models have to be developed to be ready as input for the detailed and finalized models. Where not needed is accepted to avoid :
Internal cavity and channels
The architecture of the engine must be completely defined. Main engine dimensions and the position of all accessories, circuits and auxiliaries must be fully defined.
The model has to be suitable for :
Weight assessment, center of gravity and inertia moments
Vehicle integration study
3D detailed and finalized models of all components, suitable for :
Analysis mesh O Component building
2D drawings execution
DMU build up
All the models must be completed by rounds, drafts, split lines, cavities and channels, ready to be machined.
Creation of 2D draft drawings , when needed, to be attached to Component SOR
Creation of 2D detailed drawings for all engine components, following GM Standards and Rules
ASME standard for geometry dimensioning and tolerance will be used
RECORD & RELEASE
Production / prototype part lists creation, using GM tools
Support to project meetings
Support to DRE / DSE